Print Pause

This is a short tutorial to add a mid-print pause to any 3D model using Bambu Studio. It works as well with PrusaSlicer and OrcaSlicer.

This is used for embedded magnets, mid-print assembly, or other scenarios requiring a programmed pause.

1. Adjust your slicer settings as in a standard print and slice it

2. With the layer scrollbar, look for the layer of the pause you want to do. Then go one layer above (the pause is done at the beginning of the layer, before that selected layer is printed). Right click, and add pause

3. Slice again. Now the layer after the pause will be on a different color (remember that the pause is done before that layer starts printing)

Just in case: For embedded magnets, the pause must be added to the first layer that covers the magnet hole

That's it!

Hope you find it useful!