Overview
Main specs:
Build volume 220 x 220 x 250mm
Print resolution ±0.2 mm
Print speed ≤180 mm/s
4.3 inch vertical control panel
Filament detection sensor
Resume printing after power outage
Ultra-flat coated glass print bed (heated!)
Filament supported: PLA, ABS, PETG
32 bit controller board with silent drivers
Assembly and first print
Tests
Tarantula Torture Test
Test parameters:
Tarantula design at 180% scale
0.16 mm layer height
3 perimeters - 0% infill
Antracita Glitter PLA from Leon3D
Printing speed: 30~40 mm/s
Results:
Good layer consistency. Almost perfect
Very small stringing (this depends also on the filament)
Small warping
No big blobs or seams visible
Other Tests
Small pieces
3D Hubs Marvin Keychain model (available here)
Printed at 40 mm/s and 0.16 mm layer height
Fillamentum Green Grass PLA
Fine details well done
No ghosting
No big blobs or seams
A bit of stringing on the keychain hole
Big parts
Custom bed legs
Printed at 40 mm/s and 0.28 layer height (draft mode)
ESUN Black PLA+
Awesome layer consistency
No stinging
Seams visible (due to draft mode)
Strong finished parts
Spool Holder
Custom spool holder with embossed logo
Printed at 40 mm/s and 0.2 layer height
Eryone Silk PLA
Good layer consistency
No ghosting
Just a bit of stringing
Nice surface finish